Pharmacia Biotech MultiTemp III 18-1106-33 User Manual page 23

To start MultiTemp III in 8 mode ON, follow the instructions
below:
1. Check that all tubings are firmly connected and secured
with hose clamps.
2. Switch the power on with the mains switch.
The display flashes
3. Press
The version number of the software is briefly shown on the
display. The pump motor and compressor start up, liquid
starts to circulate, and the heater will be activated if the set
temperature is greater than the actual temperature.
Add more liquid if necessary, until the level is 2 cm below the
top plate and proceed as described under Section 4.2, Setting
the temperature limit.
Resetting mode 8 to OFF
Change to mode 8 OFF with the following procedure.
1. Press
The display flashes
2. Press .
3. Press select "mode 8".
4. Press
5. Confirm by pressing
hing.
6. Wait until the display shows the actual temperature.
7. Switch off the unit using the mains switch.
The operation mode is now changed to OFF.
To start MultiTemp III in 8 mode OFF, follow the instruc-
tions described in Section 4.1, Start-up.
for start.
simultaneously with the main switch.
to select "OFF".
when the display is flas-
7. Detailed Description
.
.
21