4.1 Start-up
4. Operation
9
10
2
1
Fig. 2. Front panel of MultiTemp III.
1. Mode selector
2. Set value down
3. Set value up
4. Enter
5. Reset
Before switching on, confirm that the outlet and inlet nozzles
are either firmly connected to external equipment or to each
other and that the tubing is secured with hose clamps.
Switch the power on at the mains switch.
The version number of the software is briefly
shown on the display.
After starting the unit, the pump will circulate the liquid to
8
3
4
6. Mains switch
7. Control lamp cooling on/off
8. Display
9. Heater control sign
10. Display
4. Operation
6
7
5
9