Disassembling The Const Front; Adhesion Position Specifications For Sheet Components - FujiFilm FinePix S5200 Series Service Manual

FinePix S5200/S5600 Service Manual
2-8.

Disassembling the CONST FRONT

(1) Remove the 3 screws (M2.0 x 9.0).
(2) Remove the ASSY CASE LENS in the direction of the
arrow.
(3) Remove the 2 screws (M1.7 x 4.0).
(4) Remove the AF LED in the direction of the arrow.
(5) Peel off the SHEET PROTECT.
(6) Remove the SPEAKER ASSY in the direction of the
arrow (without pulling on the wire harness).
(7) Remove the screw (M1.7 x 4.0).
(8) Remove the STRAP LEFT in the direction of the arrow.
(9) Remove the MIC ASSY by shifting it through the notch
(without pulling on the wire harness).
(10) Remove the COVER JACK in the direction of the
arrow.
[Assembly]
Re-assemble by reversing the disassembly procedure.
[Notes on assembly]
(1) The SPEAKER ASSY wire harness should exit from the
top.
(2) Stick the SHEET PROTECT in place aligned with the
CABI F rib and run the harness between the rib and the
SPEAKER ASSY.
(3) Run the MIC ASSY wire harness out from the notched
section.
2-9.

Adhesion Position Specifications for Sheet Components

Apply K TAPE (ZS00116-100) to the HOLDER BATTERY.
Tape size: 12 x 23 mm
(1) Apply the tape equally top and bottom using the center
of the FFC as a reference point.
(2) Use the positioning guides as starting points when
applying the tape to the right.
2. Disassembly
9
7
8
6
5
10
1
1
GUIDE
2
23mm
3
4
1
2
2
3
12mm
23