Idexx SNAP Pro Quick Start Manual

Cleaning the SNAP Pro* Mobile Device
To clean the internal components (perform weekly or as needed)
1. Power off the device and
disconnect the power and/or
Ethernet cord.
activator
axle
lens
reflectors
5. Clean the 3 white reflectors, the axle,
and the activator using a new lint-free
wipe or cotton swab dampened with
70% isopropyl alcohol, mild liquid
soap and water, or a 10% bleach
solution. DO NOT clean the lens.
2. On the bottom of a powered-off
device, use a flat-tip screw driver
or coin to turn the 2 silver fasteners
counterclockwise a quarter turn.
6. After the base has dried, reattach it
to the device and ensure it is locked
into place.
3. Remove the base from the device.
7. Turn the silver fasteners clockwise
a quarter turn to lock the base into
place.
4. Clean the entire base using a lint-
free wipe or cotton swab dampened
with 70% isopropyl alcohol, mild
liquid soap and water, or a 10%
bleach solution.
8. Ensure the base and silver
fasteners are flush with the device
and locked into place. Not locking
the base and fasteners properly
can impact device performance.