Miele DA 3466 Operating And Installation Instructions page 34

Installation
To avoid scratching the deflector
plate, do not remove the protective
film between the deflector plate and
the casing until the hood has been
placed in the housing unit.
 Installation of the cooker hood is
carried out without the grease filter
placed in position. If the grease filter
has already been fitted, then it should
be removed (see "Cleaning and
care").
 When fitting a 90 cm wide cooker
hood in a 60 cm wide wall unit, whilst
the deflector plate is pulled out,
unscrew the two deflector plate
spring mounts.
34
 Lift the appliance up into the housing
from below until the spring mounts at
the side engage in the brackets.
 Push the cooker hood back against
the spacer strip.
 Note for dismantling the cooker hood:
Undoing the screws on the left and
right inside the housing releases the
spring mounts allowing the appliance
to be removed from the unit.