Miele DA 3466 Operating And Installation Instructions page 32

Installation
32
a Example: Installation without a front
panel fitted and with the front edge
of the deflector plate flush with the
front edge of the furniture housing
unit. This installation needs a shelf of
at least 95 mm deep.
b Example: Installation with a front
panel to match the kitchen furniture.
This installation requires dimension
b for the front panel plus 5 mm for
the DML 400 fixing bracket to be
added to the shelf dimension.
The shelf must be correspondingly
deeper.
The remaining installation gap must be
at least 180 mm in depth. If it is less
than 180 mm, position the appliance
further back, and reduce measurement
T accordingly.
The position of the deflector plate can
be adjusted in depth by a maximum of
35 mm at the front.
To position the cooker hood correctly,
cut the spacer strip to the required
depth T and then attach it to the back
of the appliance:
T= Depth of carcase K minus depth of
appliance G
 Cut the spacer strip supplied to
measurement T. Score along the
groove for the smaller measurement
as shown, and remove the surplus.