Routing Audio To A Zone - Redback A 4480B Operating Manual

Setup Guide

2.5.1 Routing audio to a zone

In our example we have 2 input sources and 4 zones. Selecting which zone receives which audio is very simple. The but-
tons on the left side of the LCD are the zone selection buttons.(see Fig 2.5B)
Zone Selection Buttons
For each zone there are 8 possible inputs to select and the off position which is the default. Each time one of these zone
selection buttons is pressed the next input source is routed to that particular zone. This is displayed on the screen by an
"*". For instance in our example we want to route the DVD player (input 2) to the main bar (zone 1). Pressing zone se-
lection button 1 twice will move the "*" 2 positions from the off position to input 2, thus routing the DVD player to zone
1. Continuing to press the zone 1 button will move the "*" through all the inputs and then to the off position where the
"*" will no longer be visible.
By pressing the zone 2 selection button twice we can also route the DVD player to zone 2 and so on.
In the example below in Fig 2.5C (input 2) is routed to the main bar (zone 1), the beer garden (zone 2) and the restaurant
(zone 3). While the tuner (input 1) is routed to the kitchen (zone 4).
www.altronics.com.au
Redback® A 4480B 8 In to 8 Out Audio Switcher
One
Two
Three
Four
Five
Six
Seven
Eight
INPUT4
INPUT3
DVD
TUNER
ZONES
1. MAIN BAR
2. BEER GARDN
3. RESTAURANT
4. KITCHEN
5. ZONE5
6. ZONE6
7. ZONE7
8. ZONE8
NO PRESETS ACTIVE
A 4480B
Presets
8 X 8 Audio Switcher
PA on/o
Isolate
Con rm
Cancel
Fig 2.5B
INPUTS
INPUT5
INPUT6
INPUT7
INPUT8
1 2 3 4 5 6 7 8 LOCAL PA
* ON
* ON
*
ON
* ON
ON
ON
ON
ON
Fig 2.5C
Redback® Proudly Made In Australia 15
Help
Power
Keyboard
USB