Keurig Commercial K-Cup Series Owner's Manual page 6

SECTION 1
Setup & First Brew
You cannot use your Keurig
IMPORTANT:
it has been set up for its first use.
If brewer has been exposed to temperatures
NOTE:
below freezing, allow brewer at least two hours to
reach room temperature before brewing. A frozen or
extremely cold brewer will not operate.
Ready to Brew Your First Cup
NOTE: Before making your first beverage, perform an initial cleansing brew.
Follow the steps below, skipping steps 4 and 5. The initial cleansing brew is
performed without a K-Cup ® pod.
Plug the power cord into an independent,
1.
1
fig.
grounded outlet.
Make sure the brewer is plugged in. Press the
2.
Power Button found on the front of the brewer.
3. Press the PRESS TO OPEN Button on top of the
brewer (fig. 1).
®
brewer until
6
Select a K-Cup ® pod.
4.
2
fig.
remove the foil lid or
Do not
®
puncture the K-Cup pod.
Insert the K-Cup ® pod into
5.
the K-Cup ® Pod Holder.
CAUTION: There are two
sharp needles that puncture the K-Cup
®
one above the K-Cup Pod Holder and the other
in the bottom of the K-Cup
risk of injury, do not put your fingers in the
K-Cup ® Pod Holder Assembly (fig. 2).
6. Lower the Handle completely
and firmly to close the Lid.
The Water Tank Lid will open automatically.
7.
Fill the Water Tank with filtered or bottled
3 8.
fig.
water up to the FILL LEVEL indicator
(approximately 8 oz.)(fig. 3).
Close the Water Tank Lid. The PLACE CUP
9.
Light will flash.
Place a 10 oz. mug on the Drip Tray Plate.
10.
NOTE: Do not use a clear, glass mug. Cup
sensor will not "read" the glass mug and the
PLACE CUP Light will flash.
11. Press the flashing BREW Button (fig. 4).
The HEATING Light will be illuminated.
® pod,
® Pod Holder. To avoid