QTech QSR-2920 Series Installation Manual page 27

Installation Manual
3. Router Installation
 Ensure that the distance between the slid to the bottom cabinet is 2U and
three holes on the square hole bar is 1U, as shown in Figure 3-1.
The following describes how to install a slide to the 19-inch standard cabinet.
The installation steps of the slide are as follows:
Step 1: Ensure the installation position of the slide on the cabinet and mark the
installation hole position using a marker.
The space height above the slide must be larger than the to-be-installed router chassis height
and enough margin is reserved (1U margin is recommended).
 To ensure the stability of the cabinet, try to place a heavy and high router
below the cabinet.
Step 2: Install the slide on the two sides, respectively. The slides installed on the both
sides must be at the same height. Then, tighten the fixing screws.
 The appearance and installation methods of different cabinets and slides
may vary. This section is just for your reference. Goods in kind prevail.
www.qtech.ru
Figure 3-1 The minimum slide height
27