Input Leakage Current; Input Characteristics; Output Drive Type - Transcend CompactFlash 400X Datasheet

T S 1 6 G ~ 6 4 G C
T S 1 6 G ~ 6 4 G C
T S 1 6 G ~ 6 4 G C

Input Leakage Current

Note: In Table 1 below, x refers to the characteristics described in table 2. For example, I1U indicates a pull-up resistor with a type 1
input characteristic.
Type Parameter
IxZ Input Leakage Current
IxU Pull-Up Resistor
IxD Pull-Down Resistor
Note: The minimum pull-up resistor resistance meets the PCMCIA PC Card specification of 10k ohms but is intentionally higher in the
CompactFlash Specification to reduce power use.

Input Characteristics

Type Parameter
Input Voltage
1
CMOS
Input Voltage
2
CMOS
Input Voltage
3 CMOS Schmitt
Trigger
Notes: 1) The host provides a logic output high voltage for a CMOS load of .9 x VCC. For a 5 volt product, this translates to .9 x
4.5 = 4.05 volts minimum Voh.

Output Drive Type

Note: In Table 3 below, x refers to the characteristics described in Table 4. For example, OT3 refers to Totem pole output with a type
3 output drive characteristic.
Type
OTx
OZx
OPx
ONx
Transcend Information Inc.
F 4 0 0
F 4 0 0
F 4 0 0
Table 1: Input Leakage Current
Symbol
IL
RPU1
RPD1
Table 2: Input Characteristics
Symbol
Vih
Vil
Vih
Vil
Vth
Vtl
Table 3: Output Drive Type
Output Type
Totempole
Tri-State N-P Channel
P-Channel Only
N-Channel Only
Conditions
Vih = Vcc / Vil = Gnd
Vcc = 5.0V
Vcc = 5.0V
MIN TYP MAX
VCC = 3.3 V
2.4 0.6
1.5 0.6
1.8
1.0
8
400X CompactFlash Card
MIN TYP MAX
-1 1
50k 500k
50k 500k
MIN TYP MAX
VCC = 5.0 V
1
4.0 0.8
2.0 0.8
2.8
2.0
Valid Conditions
Ioh & Iol
Ioh & Iol
Ioh Only
Iol Only
Units
µA
Ohm
Ohm
Units
Volts
Volts
Volts
V1.0