Turning The Receiver On - Solmeta GMAX-EOS2 Instruction Manual

Turning the Receiver On

To turn on the receiver, press for more than 3 seconds until the
LCD shows
The firmware version will be displayed first, then the latitude and
longitude will be displayed in the LCD.
Turning the receiver off
1.Short press ,the LCD shows a flashing
2.Short press or until the LCD shows a flashing ,
and then short press to turn off the receiver.
3.In some special situations, such as the receiver is software
frozen and it cannot be turned off via upon operation. In this
case, the receiver can be forced off by pressing and together.
Acquiring GPS/BDS signals
To acquire GPS/BDS signals, bring the receiver outdoors where the
sky is unobstructed and aim it up. Turn on the receiver to start automatic
GPS/BDS signal acquisition. To check the acquisition status, watch the
GPS/BDS indicator.
Fast red blinking: Signal not acquired
Slow green blinking: Signal acquired, 2D positioning fixed
Stable green: Signal acquired, 3D positioning fixed
When the receiver is searching the signal, a flashing is displayed
in the LCD. Once the signal acquired, the will be stable and the
latitude, longitude will be displayed in the LCD accordingly. The number
in the top left indicates how many satellites are used.
8