Delivery Content; Mode Of Operation - Bernina Pantograph Kit User Manual

Information
The Pantograph-Kit includes everything you
need to sew edge-to-edge quilting patterns
easily.
Create beautiful quilt motifs by following
either purchased paper patterns or self-
created motifs.
For your safety
› Before using the accessory please read
the instruction manual of the sewing
machine and the accessory carefully!
Preparation
Attaching the back handle
› Remove both lower screws of the back
plate (1).
– they are not needed for the further
handle attachment anymore.
› Place the space sleeves on the screws of
the handle holder (2).
› Fix the handle holder on the back plate
using the screwdriver (3).
› Hold the handles and adjust them via the
quick-clamp mechanism before tighten-
ing them (4).
› Plug the RJ11 connector on the back side
of the machine (5).
Attaching the second display
› Hold the handles and loosen the quick-
clamp mechanism at the handle holder
carefully (6).
› Insert the display holder sideways into the
opening of the handle holder (7).
› Tighten the screw in the center of the
handle holder.
› Tighten the quick-clamp mechanism (8).
› Place the display from above onto the dis-
play holder and tighten the lateral quick-
clamp mechanism of the display (9).
› Insert the HDMI plug on the back side of
the machine (10).
Activating the display
› By operating the rocker switch (I or II) at
the front and back handle guide, the cor-
responding display turns active (bright).
› The display which is not used is inactive
(dark).
Attaching the holder for laser
light and stylus
› Insert the screws into the screw holes of
the the stand profile of the holder for the
laser and the stylus (11).
› Place the holder for the laser and stylus
into the holder of the machine and tigh-
ten the screws using a screwdriver.
› Attach laser light and the stylus at the
pre-assembled the holder (11).
› Attach the pre-assembled holder at the
back stand profile (12).

Delivery content

1 Handle holder at the back (A)
1 Second display (B)
1 Holder, laser light and stylus (C)
1 Paper pantograph
1 Pantograph cover (D)
Additional material
Any tools which are needed for the assem-
bly are included in the delivery content of
your quilting machine.

Mode of operation

Using the stylus
The stylus can be used with the small or the
large pin tip.
› Insert the stylus into the holder until it
engages (waiting position).
with pattern board
› Unlock the stylus using a little pressu-
re downwards and guide the stylus pin
along one of the indentation of the fixed
pattern board (13).
› When not in use, move the stylus to the
waiting position or remove from the hol-
der.
Using the laser light
› Fix the laser pen in the device by means
of the wing nut.
› Insert the cable into the dedicated con-
nection at the back of the machine (14).
Important advice:
Never point the laser light at people!
› Press the red button at the tail end of the
laser light to switch it on or off.
› The three wing nuts allow perfect adjust-
ment to different directions of the laser
light on the pattern.
› Switch the laser off or remove it when
not in use.
with the pantograph
› Place the paper-pantograph on the table
and cover it with the pantograph cover
sheeting.
› Follow the pattern with the laser light
and quilt it (15).
5