SJC brands tasman ESSENTIALS Balmoral Assembly Instructions

Cot

Table of Contents

Download this manual

Assembly Instruction

Care & Cleaning Tips:

For general dusting / cleaning - periodically wipe the cot with a dry soft cloth. To remove

day to day spills or dirt, wipe down with a soft cloth and mild solution of warm soapy

water. Avoid scourers and steel wool as these will damadge the finish. Always dry the

cot after cleaning.

Packaging and instructions

printed on recycled materials

Balmoral cot

Save the instructions for future reference.

Assembly of this furniture is best undertaken by two people.

SJC Brands Pty Ltd abn. 58 106 988 578

4-6 Merryvale Rd, Minto, NSW 2566

p.o. box 5878 MINTO DC, NSW 2566

t. 02 9603 5000 f. 02 9603 7000

email. customer.service@sjcbrands.com.au

w.www.tasmaneco.com.au

Table of Contents

Need help?

Do you have a question about the tasman ESSENTIALS Balmoral and is the answer not in the manual?

Page 1 Avoid scourers and steel wool as these will damadge the finish. Always dry the cot after cleaning. Save the instructions for future reference. Assembly of this furniture is best undertaken by two people. SJC Brands Pty Ltd abn. 58 106 988 578 w.www.tasmaneco.com.au Packaging and instructions 4-6 Merryvale Rd, Minto, NSW 2566 p.o.
Page 2 · Re-tighten all connector bolts (at least two months after assembling the cot), as some may loosen as the cot settles. Regulary check all of the connecting bolts, making sure they are tight. · Regularly check cot for weakness in panels joints and panels. If any weaknesses are found, report immediately to SJC Brands via: www.tasmaneco.com.au ·...
Page 3 Must use lunar washers connect cot rails to headboards when fixing M6 x 50mm bolts , to headboard, fix M6 x 15mm cap screws to unused holes. To prevent falls, the base of the cot should be adjusted to the lower postion before your child can sit up.
Page 4 Connect side panels to headboards secure with M6 x 90mm bolts. M6 x 90mm bolt x 8 Fit 4 wheels to headboards secure with double ended screws and tighten. Double ended screw x 4 M3 Allen key x 2 Check all the bolts are tighten but do not over tighten & insert the mattress. M4 Allen key x 1...
Page 5 2. There is damage to the product and that damage is deemed by SJC Brands Pty Ltd to be caused by incorrect assembly, misuse or by use or storage outside of the physical or environmental speci cations of the product.