Table of Contents
Advertisement
Power (9V AC/0.8A input): please do not use any unknown power adaptor; otherwise your
ADSL2+ Router may be damaged.
RESET (reset default): First press the reset button of Router, then turn on the Router's
power for at least three seconds. It will resume the default manufacturer's setup.
LAN: Connect with your computer's NIC.
USB: Connect with your computer's USB interface
LINE (WAN): Connect to the MODEM Port of Splitter or Connect to the telephone line.
2.4 Hardware installation procedures
The procedure to install the Router can be described in general terms in the following steps and
shown as Figure 2-1:
First Step: Connecting the MODEM port of Splitter with the LINE port of the TD-8841 ADSL2+
Router by telephone line. While you need to use a telephone, please attach telephone line into the
phone of Splitter.
Second Step: Connect category 5 cable with RJ45 jacks to ADSL2+ Router's LAN port and your
computer's NIC. Or connect USB cable to ADSL2+ Router's USB port and your computer's USB
interface.
Third Step: Plug one end of the AC Power Adapter into the Power jack on the Ethernet ADSL2+
Router and the other end to a standard electrical outlet.
Last Step: Check the line connection to see if everything is ready. Power up finally.
TD-8841
External ADSL2+ Router User Guide
Figure 2-1
5
Advertisement
Table of Contents
