Table of Contents
Advertisement
TOYOTA SAFETY SENSE
Automatic High Beams (AHB)
(1)
AHB is a safety system designed to help drivers see more of what's ahead at
nighttime while reducing glare for oncoming drivers. When enabled, AHB uses an
in-vehicle camera to help detect the headlights of oncoming vehicles and tail lights
of preceding vehicles, then automatically switches between high and low beams
as appropriate to provide the most light possible and enhance forward visibility.
By using high beams more frequently, the system may allow earlier detection of
pedestrians and obstacles.
Refer to the Toyota Owner's Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
ACTIVATING THE AHB SYSTEM
(1) With the engine switch in IGNITION ON mode, turn the headlight switch to
or "AUTO" position.
(2) Push lever away from you.
(3) Press the
The AHB indicator will come on when the headlights are turned on automatically
to indicate that the system is active.
Note: Pull the lever back toward you, press the AHB switch to turn the AHB
system off.
The AHB indicator will turn off. To turn switch to "
high beam indicator "
CONDITIONS WHERE AHB WILL TURN ON/OFF AUTOMATICALLY
When all of these conditions are met, high beams will be automatically turned on
(after approximately 1 second):
• Vehicle speed is above approximately 21 mph (34 km/h.)
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights
turned on.
• There are few street lights on the road ahead.
If any of these conditions occur, the system is designed to automatically turn off
high beams:
• Vehicle speed drops below approximately 17 mph (27 km/h.)
• The area ahead of the vehicle is not dark.
• Oncoming or preceding vehicles have headlights or tail lights turned on.
• There are many streetlights on the road ahead.
switch.
" turns on.
™
(2)
" position and the manual
44
Advertisement
Table of Contents
