Replacing The Fuses; Maintaining The Headlights - Toro Workman 07235 Operator's Manual

Replacing the Fuses

There are 4 fuses in the electrical system. They are
located beneath the hood
Lift/gate (Open)
Horn/power point
Headlights
Machine fuse
Figure 50
1. Fuse block

Maintaining the Headlights

Replacing the Bulbs
CAUTION
If you install a higher wattage bulb than the
system is designed for, you may damage the
12 V power supply, or at a minimum, blow the
fuse.
Always use the specified Toro LED bulb to
prevent this issue.
CAUTION
The bulbs become extremely hot when in
operation. Handling a hot bulb can cause
severe burns and personal injury.
Always allow enough time to for the bulbs
to cool before replacing them. Use care
whenever handling the bulbs.
Specification: See your Parts Catalog.
(Figure 50).
2. Ground block
1. Disconnect the battery; refer to
the Battery (page
2. Open the hood.
3. Disconnect the electrical connector for the
30 A
harness from the connector of the lamp
assembly at the back of the headlight housing
20 A
(Figure 51).
15 A
10 A
1. Headlight housing
g202997 2. Lamp assembly
4. Rotate the lamp assembly 1/4 turn
counterclockwise and moving it rearward,
out of the headlight housing
5. Insert the new lamp assembly and headlight
housing and align the tabs in the lamp assembly
with the slots in the headlight housing
51).
6. Secure lamp assembly by turning it 1/4 turn
clockwise
7. Connect the electrical connector for the harness
to the connector of the new lamp assembly
(Figure 51).
8. Connect the battery and close the hood; refer to
Connecting the Battery (page
43
Disconnecting
41).
Figure 51
3. Harness-electrical
connector
(Figure
(Figure 51).
42).
g036872
51).
(Figure