Advertisement
Grasp the power supply handle and pull the supply out of the bay. Place one hand
Step 8
underneath to support the bottom of the supply as you pull it out of the bay. (See Figure 7.)
If the power supply resists when you attempt to pull it out of the bay, the switch is probably
not fully in the OFF (O) position, or the captive installation screw at the top of the supply
is not fully loosened. Turn the power switch fully counterclockwise to OFF (O), and check
the captive installation screw, then try removing the supply again.
To prevent dropping the power supply, use both hands to handle it. The power supply
Caution
weighs approximately 14 pounds.
Figure 7
Handling a Power Supply
DO NOT SHIP WITH
POWE R SUPP LY
INSTA LLED
INPU T VOLT AGE
: 40-72 V=
INPU T CURR ENT
: 24-13 A
NO SER VICE
If the power supply bay is to remain empty, install a cover plate (Product
Step 9
Number MAS-7KBLANK) over the opening and secure the captive mounting screw. If you
are installing a replacement power supply, proceed to the section "Inserting a Power
Supply." Otherwise, reconnect all power and interface cables on the rear of the chassis and
restart the system.
FAST ENER TO
BE FULL Y ENGA
BEFO RE OPER
GED
ATING POWE R
SUPP LY
ABL E COM
PON ENT S INSI
DE
700-Watt DC-Input Power Supply Installation and Replacement Instructions
Installation
15
Advertisement
