Finelite HP-4 Installation Instructions

HP-4 Recessed with Regressed Diffuser Tech Zone 6"

Starter/Independent Installation Instructions

Scan QR code for
Step 1
helpful video(s)
0 - 10V
Dimming
Diffuser
Remove diffuser and set aside to prevent from
getting dirty or damaged.
Step 3
Secure to
Structure
(by others)
#8-18 x 1/4" Screws
(provided)
T-Bar Brackets
(provided)
Install T-Bar bracket onto luminaire. Secure with #8-18 x 1/4" screws (provided).
Secure luminaire to building structure using tie-wire, as per code.
Note: All power connections to be installed to
local/national codes by a Certified Electrician.
Step 2
Place luminaire on ceiling grid.
Step 5
Dimming
(Purple)
Dimming
(Gray)
Remove conduit plate from end of luminaire and insert
conduit through conduit plate. Secure conduit with jam nut.
NOTE: Purple and gray wires are for Low Voltage Control.
Finelite, Inc. • 30500 Whipple Road • Union City, CA 94587-1530 • (510) 441-1100 • Fax: (510) 441-1510 • www.finelite.com
TECH ZONE 6" COLLECTION - CENTER-TO-CENTER T-BAR SPACING
5"
1"
4"
6"
Tech Zone 6" (C1)
5"
Step 6
Secure to
(by others)
Jam Nut
Conduit Plate
Conduit Plate
(Provided)
Make electrical connections and reinstall conduit plate to luminaire.
5"
5"
1"
4"
6"
Tech Zone 6" (C2) Tech Zone 6" (C2T)
5"
1" 1"
1
4"
4"
6" 6"
Tech Zone 6" (C3) Tech Zone 6" (C3F)
1
Structure
1"
4"
6"
#8-18 x 1/4"
Screw (provided)
Conduit Plate
1