Toro Greensmaster 800 Operator's Manual page 13

Parking Brake
The parking brake (Figure
service brake. Fully engage the service brake and push the
parking-brake knob to allow the service brake to rest on the
parking-brake pin. Engage the service brake to release the
parking brake. You must release the brake before you engage
the traction drive.
Figure 12
On/Off Switch
The on/off switch (Figure
control panel. Move the switch to the O
the engine and the O position to shut off the engine.
FF
Operator Presence Control (Optional)
If equipped, the operator presence control
located on the rear of the handle. Push the operator presence
control against the handle. If equipped, the operator presence
control must be engaged before moving the traction-drive
lever or the engine shuts off.
G016976
Figure 11
12) is located at the base of the
G016977
10) is located on the top of the
position to start
N
(Figure
Reel-Drive Lever
The reel-drive lever
corner of the machine. The lever has 2 positions: E
and D
ISENGAGE
reel or to the left to disengage the reel.
g016976
1. Reel-drive lever
Choke Lever
The choke lever
engine. The lever has 2 positions: R
the lever to the C
After the engine starts, move the lever to the R
g016977
1. Choke lever
Fuel-Shutoff Valve
10) is The fuel shutoff valve
of the engine near the choke lever. The valve has 2 positions:
C and O
LOSED
when storing or transporting the machine. Open the valve
before starting the engine by rotating the lever down.
13
(Figure 13) is located on the right front
. Move the lever to the right to engage the
1
G016978
Figure 13
(Figure 14) is located on the left front of the
and C
UN
position when starting a cold engine.
HOKE
1 2
Figure 14
2. Fuel-shut off valve
(Figure 14) is located on the left front
. Move the lever up to the closed position
PEN
NGAGE
g016978
. Move
HOKE
position.
UN
g024364
g024364