Table of Contents
Advertisement
Steam12Maintenanceinstruction 10and care
Glass top
•Persistent stains may require vigorous rubbing with
nylon scourer or creamed powder cleansers. Household
enamel cleaners are available, follow the manufacturer
instructions in their use. Harsh abrasive cleaners, powder
cleaners, steel wool or wax polishes should not be used.
•Do not use the glass top as a work table.
Burner caps & crowns
•These can all be lifted off and removed for separate
cleaning.
•Ensure burner caps and crowns are thoroughly
dried after cleaning or spillage.
•When cleaning the burner, ensure that all the flame ports,
injector hole and other holes are free of any blockage.
(Fig 13,14)
Care and cleaning
Notes on cleaning
Remove the water from the tray with the sponge after each use.
Clean all accessories after each use and let them dry.
What to do if
Phenomenon
Burner will not light...
Burner lights back to injector...
Burner has explosive ignition...
lgnitor not sparking...
WARNING:-
Do not spray aerosols in the vicinity of this hob while in operation. Some propellant gases can break down
when heated and produce corrosive vapours which will attack some materials.
Articles which are made from flammable materials should not be stored in drawers or cupboards immediately
below this hob.
Do not store articles within 50mm of the base.
Do not touch spark ignitor while lighting the burner.
Where this appliance is installed in a marine craft or in caravans, it shall not be used as a space heater.
Reason
Air
in
gas
line
Blockage
in
Ignition
not
Battery
is dead
Burner
not fitted
Excessive
lint
Excessive
gas pressure
Excessive
gas pressure
Electrode gap
lgnitor connections loose
Battery is
dead
•If necessary, use a matchstick or brush tocar ports.
•After cleaning, ensure the burner caps
are reassembled properly into position.
•After cleaning service, when assembling the burner
crown and caps, care must be taken to ensure the spark
plug is not knocked. The spark plug will crack if knocked
and may give rise to flame ignition problem.
Solution
line
sparking
correctly
up
of
burner mixing
tube
excessive
Purge gas line
Trace
back
clear
&
Check
lead
electrode
&
Replace
battery
Fit
burner in
correct
position
Remove
&
clean
burner
Check gas regulator pressure
adjust
if necessary
Check gas regulator pressure
adjust if
necessary
Check gap,
adjust
if not between
4-5 mm
Check connections to
ignitor,
replace
if
faulty
Change
a
new battery
&
&
Advertisement
Table of Contents
