Maintenance Instructions; Storage And Transport Instructions - Sherman digitec DIGITIG 200DC MULTIPRO User Manual

A full list of consumable parts and spare parts is available on the website www.tecweld.pl and at TECWELD. You can buy these parts
directly.

13. MAINTENANCE INSTRUCTIONS

As part of daily service, keep the welding machine clean, check the condition of external connections and the condition of electric wires
and cables. Replace consumable parts regularly.
Periodically clean the inside of the device by blowing it with compressed air to remove dust and metal filings from the control boards as well as
wires and electrical connections. A general inspection and condition of the electrical connections should be carried out at least once every six
months, in particular:
- the state of electric shock protection
-
isolation status
- security system status
- proper functioning of the cooling system
Damage resulting from operating the welding machine in improper conditions and failure to comply with maintenance instructions are not
covered by warranty repairs.

14. STORAGE AND TRANSPORT INSTRUCTIONS

The device should be stored at a temperature of –10 ° C to + 40 ° C and relative humidity up to 80% free of corrosive fumes and dust. Packaged
equipment should be transported using covered means of transport. During transport, the packed device must be secured against slipping and secured
in a proper position.
15. SET SPECIFICATION
1. Source DIGITIG 200DC MULTIPRO
2. TIG welding torch
3. Electrode cord
4. Ground cable with a clamp
5. Operating instructions
6. Packaging
1 piece.
1 piece.
1 piece.
1 piece.
1 piece.
1 piece.
15