Parameter Settings - Sherman digitec DIGITIG 200DC MULTIPRO User Manual

REMOTE
LED indicating that the device is in remote control mode. The LED will light up
automatically after connecting the remote control plug to the socket (4)
OC
The LED indicates incorrect welding current parameters or a device failure. On
the display also shows the error code "E00"
OT
Overheat protection - the power source is equipped with a thermal,
automatic circuit breaker. If the welding machine temperature is too high, the protection disconnects the welding current, the OT diode lights up and
the error code "E00" appears on the display. After the temperature drops, the circuit breaker will reset automatically.
The display can also show other error codes: E01 Incorrect mains parameters E02
Internal controller error
E03 Incorrect mains parameters and internal controller error

9. PARAMETER SETTINGS

9.1 MMA method
After selecting the MMA method, it is possible to adjust the welding current and the ARC FORCE function. During welding current adjustment
Cur r ent Cur r ent Cur r ent Cur r ent
the LED is on the LED is on the LED is on the LED is on and the ARC FORCE function can be adjusted after the diode lights up and the ARC FORCE function can be adjusted after the diode lights up and the ARC FORCE function can be adjusted after the diode lights up and the ARC FORCE function can be adjusted after the diode lights up
ARC FORCE function
The ARC FORCE function allows you to adjust the dynamics of the welding arc. The shortening of the arc length is accompanied by an increase in the
welding current, which stabilizes the arc. Decreasing the value gives a soft arc and a smaller penetration depth, while increasing the value causes
deeper penetration and the possibility of short arc welding. When the ARC FORCE function is set to a high value, it is possible to weld while maintaining
the minimum arc length and high electrode melting speed. Adjustment range: 0 - 100A
9.2 TIG method
Use the welding method selection button (B) to select TIG HF or TIG Lift welding. Switch pulse on or off (A). Set the welding parameters:
Cur rent
Ar c For ce
Arc Force. Arc Force. Arc Force. Arc Force.
10