Westfalia 83 72 29 Instruction Manual page 7

Please note the included General Safety Notes and the
following safety notes to avoid malfunctions, damages or physical
injuries:

Make sure the voltage corresponds to the type label on the unit.

Persons with limited physical, sensorial or mental abilities are not allowed to
use the unit, unless they are supervised and briefed for their safety by a
qualified person.

Disconnect the machine from the power supply before inserting the tool,
cleaning or servicing it.

Do not use grinding discs with a diameter more than 25.1 mm!

Do not force the tool.

Use clamps or a vice to hold the workpiece.

The use of any accessory or attachment other than those recommended in
this instruction manual may present a risk of personal injury.

Do not touch the rotating chuck and the tool bit in it, as this may cause cuts or
burns.

Always hold the drill and milling machine firmly in your
hand. The tool bit can suddenly get stuck, which may
cause injuries.

During operation always wear safety goggles and if necessary ear protectors
and a face mask, depending on the used material.

Keep the drill and milling machine out of reach of children. The machine is not
a toy.

Do not press the axle locking pin (5) while the machine is running!

Operate the unit only indoors or in dry areas.

Do not stress the cord. Do not bend the cord and keep it away from hot and
sharp surfaces. Do not wind the cord around the unit.

Keep the work area clean. Dress appropriately.

Should the unit become damaged do not use it and have it repaired by a
professional or contact our customer support department. Do not disassemble
the unit or try repairing it yourself.
Safety Notes
3