1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the heat sink (see
5.
Remove the system board (see
To remove the IR sensor board::
1.
Disconnect the IR sensor board cable from the connector on the computer (1).
2.
Remove the IR sensor board M2.0 × 3.0 screw from the IR board (2).
3.
Remove the IR board from the computer (3).
Reverse this procedure to install the IR sensor board.
(Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page
32).
Heat sink on page
45.
System board on page
29).
30).
47).
Component replacement procedures
59