Hard drive, drive rubber holder, and cable
Table 5-4
Hard drive, drive rubber holder, and cable descriptions and part numbers
Description
Hard drive, 1 TB, 7200 rpm
Hard drive connector
Before removing the hard drive, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
To remove the hard drive (select products only)
1.
Disconnect the hard drive connector from the system board (1).
2.
Remove the four Phillips M2.0 × 3.0 screws securing the hard drive (2).
3.
Lift the hard drive assembly out of the computer (3).
(Preparation for disassembly on page
Bottom cover and rubber feet on page
Battery on page
32).
Spare part number
L06427-855
L87952-001
29).
30).
Component replacement procedures
35