Toshiba IP5000 User Manual page 140

Administrator Programming
IP5131-SDL Settings
Station ID
From the IP Configurations screen, choose Network >
Station. The Station ID screen displays (shown right).
The current Station ID displays.
To Change or Add Information on this screen
1. Enter the New Station ID to change or add a Station
ID.
2. Press the Set soft key to accept the change
...or press the Cancel soft key to cancel the change and
go to the Network Setting screen.
Notes
• Use the dial pad (1~0) to change or enter a new Station ID. Press
backspace.
• You can enter a maximum of seven digits.
• Pressing the Set soft key can give you an Error Screen if you incorrectly entered
the Station ID.
• Press the OK soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the appropriate
setting screen (in this case the IP Address) and the address that resulted in an error
will be displayed.
Node Number
1. From the IP Configurations screen, choose Network >
Screen 2 > Node. The current Node displays
(shown right).
2. Enter the Node. You must be first program this node in
eManager, Program 150, FB09.
3. Press the Set soft key to accept the change
...or press the Cancel soft key to cancel the change and
go to the Network Setting screen.
Refer to
Note
122
Station ID Notes above.
Station ID
2000
Backspace = Vol-Down
[Set]
Node
1
Backspace = Vol-Down
[Set]
Strata CIX IP5000-series Telephone UG
:Current
:New
[Cancel]
Config
Vol
▼
to
:Current
:New
[Cancel]
Config
10/08