Elation CUEPIX 16IP DTW User Manual page 13

I N S T A L L A T I O N I N S T R U C T I O N S
INTERLOCKING PANELS
The fixture includes integrated alignment pins and interlocks, which are used to connect
multiple panels horizontally and vertically to create seamless custom matric designs. See
images below for interlocking steps.
THE PINS AND INTERLOCKS ARE FOR ALIGNMENT PURPOSES ONLY!
EACH PANEL MUST BE SECURED WITH ITS OWN CLAMP(S) AND SAFETY CABLE!
FOR MULTIPLE PANEL RIGGING, USE ONLY THE FIXED YOKE BRACKET!
1. Push out alignment pins on panel by pulling up and holding round knob while sliding out.
Release round knob to lock alignment pin into fully extended position. MAKE SURE EACH
ALIGNMENT PIN IS FULLY EXTENDED, AND THE ROUND TAB IS IN THE LOCKED
POSITION!
FIXED YOKE
BRACKET
2. UNLOCK/OPEN interlocks on panel by pulling up and holding lock while turning 45
degrees to 9/3 o'clock position. Release lock so it sits completely into position. MAKE
SURE EACH INTERLOCK IS COMPLETELY IN THE 9/3 O'CLOCK UNLOCK/OPEN
POSITION!
INTERLOCK
13
ALIGNMENT PIN
INTERLOCK
UNLOCK/OPEN
POSITION