Page 1
SAN12 (6904-002020 <00>) Wood 13mm (1/2 in.) (1/8 in. Sanus Systems 2221 Hwy 36 West Saint Paul, MN 55113 USA Customer Service Americas: 800-359-5520 • 651-484-7988 • info@sanus.com Europe, Middle East, and Africa: + 31 40 2324700 • europe.sanus@milestone.com Asia Pacifi c: 86 755 8996 9226 • sanus.ap@milestone.com accents.sanus.com...
Page 2
WARNING: This product Wood stud walls Do Not Caution / Warning contains small items that could Tools required be a choking hazard. 6904-002020 <00>...
Page 4
CAUTION: IMPORTANT SAFETY INSTRUCTIONS – SAVE THESE INSTRUCTIONS – PLEASE READ ENTIRE MANUAL BEFORE USING THIS PRODUCT The SAN212 is designed to support audio and video accessory equipment; it is NOT designed to support a television. Specifi cations: Shelf capacity - DO NOT EXCEED: 22.6 kg (50 lbs) CAUTION: Avoid potential personal injuries and property damage! ...
Page 5
[03] x 2 [04] x 8 [05] x 2 [02] x 1 [06] x 2 [01] x 1 [07] x 4 [08] x 1 [09] x 1 1/4 in. 1/4-20 x 3/8 in. 1/4 x 2 in. 1/4 in. 1/4 x 2.5 in. [13] x 1 [10] x 4 [11] x 4...
CAUTION: Wall Mounting Wood Stud Mounting CAUTION: Improper use could reduce the holding power of the lag bolt. To avoid potential injuries or property damage: Pilot holes MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 3 mm (1/8 in.) diameter drill bit. ...
Page 7
13mm (1/2 in.) (1/8 in. < 16 mm (5/8 in.) Locate stud. Verify the center of the stud with an awl or thin nail or use an edge to edge stud fi nder. [02] Level the wall plate [02] and mark the hole locations.
Page 8
[01] Mount column [01] onto wall mount [02] by aligning [02] the slots of the column's locking bar with the hooks on the wall mount [02]. When the column To lock the [01] is pressed column [01] in onto the wall place, press the mount [02], the rear locking bar...
Page 9
[05] Slide shelf brackets [03] Adjust shelf brackets with nut plates [05] into [03] to desired the channel of the column positions. [01]. [14] Using the 5/32 in hex key [14], tighten the screws [10] of the nut plates [03] to lock the shelf brackets [03] into position.
Page 10
Slide glass shelves [06] under upper lip of shelf brackets [03] and lay them fl at onto the shelf rests [04]. [03] [04] [06] Cables and wiring for appliances can be routed into the side channels of the column [01] and covered with the side caps [07]. [01] [07] [07]...