Table of Contents
Advertisement
Connecting a computer (COMPUTER IN 2 connector)
You can project the picture of analog RGB or digital RGB signal from a computer by using the COMPUTER IN 2 connector.
Check that the power supplies for the projector and for the computer are off before connecting the cables.
USB
MONITOR
OUT
CONTROL
To AUDIO IN jack
Notes
(Please also read "Notes" on page 22.)
• DVI digital cable needs to be purchased separately when you input a digital RGB signal.
• Although infrequent, noise might be generated on the screen depending on the types of computer and connection cables. Should this occur, reduce the
refresh rate of the computer signal, or lower the resolution. Use of connection cables that are 2 m or shorter is recommended.
• The input signal specifications of the DVI port of the projector conform to DVI 1.0 specifications; however, contents protection is not supported. Note that
there is no guarantee for the operations not specified in this specification.
COMPUTER IN 1
COMPUTER IN 2
( Y/P
)
B
/P
R
VIDEO IN
AUDIO
IN
R - AUDIO - L
VIDEO
S-VIDEO
To COMPUTER IN 2 connector
Be sure to connect in the proper
direction.
DVI cable (supplied)
Audio cable (supplied)
COMPUTER IN 2 connector (DVI connector)
For use as both analog RGB (2) input and digital RGB input. At shipping
from factory, it set for use as Analog RGB (2) input. Change the setting on
the menu screen when using as Digital RGB input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB (1)/analog RGB
(2)/digital RGB) and Y/P
/P
input.
B
R
To monitor port
CONTENTS
45
Computer
ø3.5mm Stereo mini-jack
To audio output port
23
Advertisement
Table of Contents
