Velleman VM119 Manual page 7

CONFIGURATION OF LEFT AND RIGHT RELAY OUTPUT
1. Push 'setup'-button repeatedly to configure either left relay (LD2 lights) or right relay
(LD3 lights).
2. Confirm your selection with a long push (LD4 flashes 3 times).
The selected relay will remain ON.
3. Push 'setup'-button a number of times, depending on the desired mode (see table).
At each press, LD1 will flash a # of times, indicating the current mode.
4. Confirm with a long push (LD4 flashes 3 times).
The selected relay will turn off and the unit is ready for use.
The unit will return to normal operation when left idle for 10s. The current mode will not be
changed.
If necessary, repeat sequence for the remaining channel.
Factory defaults: left relay-output (CH1): 0.5s timer right relay-output (CH2): 1h timer
USE
Pressing a transmitter button will operate both outputs simultaniously.
Each relay will behave according to the selected mode.
In '0.5s timer'-mode, the relay will remain on for as long as the remote button is held.
In 'ON/OFF'-mode, the relay will toggle between ON and OFF every time the remote button is pushed.
Use
flashes Mode
1 ON/OFF
2 0.5s timer
3 5s timer
4 30s timer
5 1min timer
6 5min timer
7 15min timer
8 30min timer
9 1h timer
7