Velleman VM119 Manual page 6

Configuration
1. Hold 'setup'-button. LD1 turns on.
2. Hold a remote button (1..8)
3. LD4 will light when the button has been stored
4. Release all buttons
Repeat steps 1 trough 4 to learn other remote buttons or remotes.
31 transmitters or transmitter-buttons can be stored.
If the memory is full, both LD1 and LD4 will flash rapidly.
TO REMOVE ALL STORED REMOTES FROM MEMORY AND TO RETURN TO FACTORY DEFAULTS
1. Turn off the power.
2. Hold 'setup'-button.
3. Turn on power. LD1 and LD4 will start flashing
4. Release 'setup' when LD1 and LD4 stop flashing
This process takes about 10 seconds.
If the button is released before the leds stop flashing, the memory will not be cleared.
The unit will now respond to the default code only.
6