LG LA408AB Owner's Manual page 5

Making the Terminal
Connections
1. Expose the end of the wire using nippers or a
cutter by about 10 mm and twist.
2. Attach ring lugs to wire ends.
3. Loosen the screw by using the driver. Connect
the wires, then tighten the screw.
,
Note
When you tighten the screw, be careful not to
apply too much torque as doing so may damage
the screw.
Power Connection Wires (not
supplied)
Twist
10 mm
* If you have the factory original or some other
car audio unit without a remote output for the
amplifi er, connect the system remote control
terminal (REM) to the power supply.
Notes on the power supply
 Connect the + 12 V power supply wire only after
all the other wires have been connected.
 Be sure to connect the ground wire of the unit
securely to a metal point of the car. A loose
connection may cause a malfunction of the
amplifi er.
 Be sure to connect the remote control wire of
the car audio unit to the remote terminal.
 When using a car audio unit without a remote
output on the amplifi er, connect the system
remote control terminal (REM) to the power
supply.
 Use a power supply wire with a fuse attached (60
A).
 Make sure that the vehicle's battery wires
connected to the vehicle (ground to chassis) are
of a wire gauge at least equal to that of the main
power wire connected from the battery to the
amplifi er.
Connecting
To a metal point
of the car
* Remote output
Car audio unit
Fuse (60 A)
4 5
Ground to
chassis
+ 12 V car battery
5
2