Loading The Batteries - Canon 10x42L IS WP Instructions Manual

Image stabilizer
Hide thumbs Also See for 10x42L IS WP:
Table of Contents

Advertisement

Loading the Batteries

Battery Life (Continuous Use)
Size-AA lithium batteries
Size-AA Ni-HN batteries
Size-AA alkaline batteries
Size-AA manganese batteries are not recommended due to their low energy.
z
z
Change batteries when the binoculars are dry and there is no moisture
z
z
or dirt.
Be careful not to let moisture onto the inner side of the battery chamber
z
z
cover or into the chamber. If there is moisture, make sure to remove it
and adequately dry it off before changing batteries.
Wet batteries may result in battery leakage and failure.
z
z
1
Open the cover.
Use a coin or a similar item to turn the
z
z
lock screw 90 degrees as shown by
the arrow. Then open the cover.
2
Load the batteries.
Load two batteries in the correct + and
z
z
– orientation as shown on the battery
cover.
3
Close the cover.
Hold down the battery chamber cover
z
z
and tighten the lock screw.
25˚C / 77˚F
Apporox. 8 hours
Apporox. 6 hours
Apporox. 2.5 hours
(Based on Canon's testing conditions.)
–10˚C / 14˚F
Apporox. 3.5 hours
Apporox. 2.5 hours
Apporox. 10 minutes
ENG-8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents