Using The Image Stabilizer - Canon 10x42L IS WP Instructions Manual

Image stabilizer
Hide thumbs Also See for 10x42L IS WP:
Table of Contents

Advertisement

Using the Image Stabilizer

While you look through the binoculars, the image may be shaking and
difficult to see since your hands are holding the binoculars. In such a
case, the Image Stabilizer can help steady the image.
There are two ways to use the Image Stabilizer. You can turn on the
Image Stabilizer as long as you hold down the Image Stabilizer button
and or you can turn on the Image Stabilizer for 5 minutes.
The Image Stabilizer may not be able to compensate for severe shaking.
z
z
If the binoculars are attached to a tripod, it will compensate for the
z
z
small vibrations unique to tripod use.
If the binoculars face down for more than 10 seconds, such as when
z
z
they are hanging from the strap, the Image Stabilizer will turn off to
conserve power. To use the binoculars in downward direction, keep
pressing the Image Stabilizer switch.
When the battery power is low, the Image Stabilizer may generate
z
z
noise and vibration. The image stabilization is not affected by this.
Even without batteries loaded, the binoculars can still be used as is.
z
z
ENG-11
■ Holding down the button
The Image Stabilizer operates
continuously while you hold down the
button. When you let go of the button, the
Image Stabilizer stops operating.
■ Five-minute operation
Press the Image Stabilizer button slowly
and quickly let it go, and the Image
Stabilizer will operate continuously for
about five minutes.
To stop the Image Stabilizer operation,
press the button again.
The lamp lights while the Image
z
z
Stabilizer is on.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents