Specify Dhcp Server Settings - TP-Link TL-WA1201 User Manual

Chapter 3
Note:
If your access point works in Range Extender mode or Multi-SSID mode, select
IP address.
4. Leave other parameters as the default settings.
5. Click Save.
Tip:
After setting a static IP address, you can use the new IP address to log into the web management page besides
http://tplinkap.net.
3. 3.

Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) server is set to Auto. It will
automatically assign valid IP addresses to clients when the DHCP server of the host
router/AP is disabled, and will stop working when the DHCP server of the host router/
AP is enabled so as to avoid IP conflict. You can change the DHCP server settings if
necessary.
Note:
If you disable the DHCP server and there is no other DHCP server within your LAN, you have to configure the IP address
for each client manually.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to Settings > Network
3. Enable DHCP Server.
4. Enter the starting and ending IP addresses in the
5. Leave other parameters as the default settings.
6. Click Save.
The DHCP server of the access point works when it is set to Enabled, or when it is set to
Auto with the DHCP server of the host router/AP disabled. When it is working, you can
view the DHCP clients in the DHCP Client List, and reserve IP addresses (only in Access
> DHCP Server.
Customize Your Network
Use the following IP address
IP Address Pool.
and set the
15