Change The Lan Settings; Specify Dhcp Server Settings - TP-Link TL-WA3001 User Manual

Chapter 7
7. 1.

Change the LAN Settings

The access point is preset with Dynamic IP, which allows it to dynamically obtain an IP
address and gateway from the main router/AP. It is recommended that you keep the
default LAN settings to avoid IP conflict with the main router/AP or other devices on
your local network.
If you want to set a static IP address for the access point, follow the steps below:
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to Internet > LAN.
3. Choose Static IP.
4. Set an IP address, which should be in the same subnet as the main router/AP.
5. Leave other parameters as the default settings.
6. Click SAVE.
Tip:
After setting a static IP address, you can use the new IP address to log into the web management page besides
http://tplinkap.net.
7. 2.

Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) server works in Auto mode
to avoid IP conflict. It will automatically assign IP addresses to clients from its IP address
pool only when the DHCP server of the main router/AP is disabled.
You can change the DHCP server settings if necessary, and you can reserve LAN IP
addresses for specified client devices.
Note:
If you disable the DHCP server and there is no other DHCP server within your LAN, you have to configure the IP address
for each client manually.
1. Visit http://tplinkap.net, and log in with the password you set for the access point.
2. Go to Internet > DHCP Server.
Customize Network Settings
40