Regulus TP44 Installation And Operation Manual page 5

Heating: connect the two connecting cables of the controlled device to terminals No. 3 (NO – normally
open) and No. 2 (COM).
Cooling: Connect the two connecting cables of the controlled cooling unit to terminals No. 2 (COM) and No.
1 (NC - normally closed).
- For safety reasons, the removed inner cover must be replaced immediately after connecting the cables.
The equipment shall be installed and connected by a qualified professional. Always follow the manu-
facturer's instructions when connecting the thermostat to a heating or cooling system.
Thermostat Wiring Diagrams for Heating:
For equipment requiring 230V power supply.
N
○
230 V
○
L
powered device
napájené zařízení
1 2
NC COM
For equipment requiring potential-free contact.
3
NO NC
Picture of the rear panel
with open door (installs
1 2
COM NO
on a wall)
kotel
boiler
3