1. Popis The digital thermostat is suitable to control temperature in a living room and is very easy to use. It allows you to control heating or cooling when the room temperature is lower or higher than set by the user. Installation is very easy thanks to the step-by-step instructions.
Set temperature 3. LCD Display Time Cooling symbol Heating symbol Program number Operation mode Room temperature Low battery indication Manual operation symbol 4. Operating Modes for 5 sec., that opens operating mode selection. Press + or – to Keep pressed the middle of the circle select heating mode (HEAT) or cooling mode (COOL), press to confirm.
7. Manual Temperature Setting Press + or - to set the temperature, then press or wait for 15 seconds before the values are accepted. The symbol is displayed. The thermostat will run following this value until the program changes or until the .
Page 5
Picture of the rear panel with open door (installs on a wall) Heating: connect the two connecting cables of the controlled device to terminals No. 3 (NO – normally open) and No. 2 (COM). Cooling: Connect the two connecting cables of the controlled cooling unit to terminals No. 2 (COM) and No. 1 (NC - normally closed).