Programmable room thermostat - user’s manual Model: TP07 - 01 Thank you for buying Regulus programmable room thermostat. This product has been manufactured with regard to its quality, reliability and user comfort. The thermostat adjusts switching heating on and off to the character of the space heated.
Page 3
Installation: This thermostat is intended for indoor use only. It should be mounted on an inner wall, about 150cm above the floor, located where room temperature changes can be felt thanks to freely circulating air. Do not install above a heat source (a TV set, heater, fridge etc.) or to places where it may be exposed to direct sunshine, draught,...
Page 4
Thermostat commissioning and programming: • Open the bottom compartment door and insert batteries. Mind the right polarity. • Press open the door on the right side. • Slide the mode selector to the „heat“ position. • Setting the time: Select either 12- or 24-hour display mode by pressing 12/24 HOURS pushbutton (4). •...
Temporary program override: • Change the desired temperature by pressing UP or DOWN arrow. The override temperature is highlighted by a flashing program number. • This temporary override can be cancelled by pressing HOLD CLEAR (8) button. If not cancelled, this temperature override is valid until the next time section (program) starts.
Page 6
Guidelines on a proper disposal of this product as required by the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE) European Directive 2002/96/EC requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Need help?
Do you have a question about the TP 07-01 and is the answer not in the manual?
Questions and answers