TEC EO1-33015 Owner's Manual page 19

8. LOADING THE MEDIA
8. The media is now loaded and the sensor position is set.
Batch type:
Cutter type: Where a cutter is fitted load the media as standard and feed it through the cutter
module.
NOTES: 1. Be sure to cut the backing paper of label. Cutting label will cause the glue to stick to the
cutter, which may affect the cutter quality and shorten the cutter life.
2. If the top edge of label winds onto the platen in cut issue, set the DIP SW 1-5 of the B-672
to ON. For the B-682, contact your authorized TOSHIBA TEC representative to change
the Operation Panel setting.
3. Use of tag paper with the thickness exceeding the specified valve may affect the cutter life.
Cutter Module
Media Outlet
Media
Media
8-4
EO1-33015
8. LOADING THE MEDIA
Fig. 8-6
Fig. 8-7