Table of Contents
Advertisement
APPENDIX 1 SPECIFICATIONS
A1.3.1
Media Type (Cont.)
Label dispensing mode
Item
c
Media pitch
d
Media length
e
Width including backing paper
f
Label width
(See NOTE 5.)
g
Gap length
h
Black mark length (Tag paper)
i
Effective print width
j
Effective print length
k
Print speed up/slow down area
Thickness
Maximum effective length for on the fly issue
Maximum outer roll diameter
Roll direction
Inner core diameter
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. The media length specifications for use of the cutter are:
*1: When issuing a label using the swing cutter, label length should be 35.0 mm – (Gap length/2).
*2: The rotary cutter does not support the print speed of 10"/sec.
When using the Rotary Cutter, be sure to install the Ribbon Saving Module (B-9904-R-QM). Failure to do
this may cause a paper jam or ribbon error.
3. When marking black marks on the label rolls, they should be marked at the gaps.
4. "On the fly issue" means that the printer can feed and print without stopping between labels.
5. There are restrictions in use of the media which is narrower than 50 mm. For details, refer to TOSHIBA TEC
service representative.
A1.3.2
Detection Area of the Transmissive Sensor
The Transmissive Sensor is movable from the centre to the left edge of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
<Label>
Min. 2.0 mm
(Min. 6.0 mm when using
the cutter module.)
Batch mode
Label
10.0 – 1500.0
Tag
10.0 – 1500.0
8.0 – 1498.0
30.0 – 112.0
(See NOTE 5.)
27.0 – 109.0
Label
6.0 – 1496.0
Tag
8.0 – 1498.0
Label
Tag
Area to be detected.
Sensor position
Min. 12 mm
Strip mode
3"/sec., 6"/sec.: 38.0 - 1500.0
25.4 – 1500.0
----
3"/sec., 6"/sec.: 30.0 – 1500.0
3"/sec., 6"/sec.: 25.0 – 1498.0
23.4 – 1498.0
50.0 – 112.0
47.0 – 109.0
2.0 – 20.0
10.0 – 104.0±0.2
3"/sec., 6"/sec.: 23.0 - 1496.0
21.4 – 1496.0
3"/sec., 6"/sec.: 28.0 – 1498.0
----
Centre of media
Label
Gap
Label
Sensor is movable
within this range.
EA1- 3
ENGLISH VERSION EO1-33034
Cut mode
Rotary cutter
(*2)
30.0 – 112.0
27.0 – 109.0
6.0 – 20.0
2.0 – 10.0
1.0
0.13 – 0.17
0.15 – 0.29
1361.0
Ø200
Inside
Ø76.2±0.3
Print side
Media feed direction
A1.3 Media
[Unit: mm]
Swing cutter
38.0 – 1500.0
25.4 – 1500.0
25.0 – 1498.0
(*1)
23.0 – 1496.0
23.0 – 1498.0
Advertisement
Table of Contents
