Retrieving Stored Traffic Messages; Warning; Temporarily Interrupting The Tim Standby Mode (Before Driving Into A Car Wash); Standby Mode (Before Driving Into A Car Wash) - Blaupunkt LONDON RDM 169 Operating Instructions Manual

Traffic Memo (TIM)
During the TIM standby time, a
power antenna will remain extend-
ed. Please observe the warning
note.
Retrieving stored traffic
messages
Up to four traffic messages can be record-
ed. TIM 1 is always the most recent mes-
sage.
If there are no messages recorded, "No TIM"
will appear in the top line of the display.
To retrieve stored messages,
• press TIM briefly.
TIM1 is the most recent message and will
be played back first. It is followed by TIM2,
etc. The flashing red arrow indicates which
message is currently being played back.
The DOT display shows the recording time
of the retrieved message.
If you would like to retrieve a specific mes-
sage,
• press the corresponding key.
After the last message, the audio system will
switch back to the previous operating mode.
Press TIM to return to the previous operat-
ing mode immediately.

Warning

An automatic power antenna might be
damaged in a car wash
An automatic power antenna will remain
extended when TIM is active and you switch
the audio system off.
If you drive through a car wash with the an-
tenna extended, this could cause serious
damage.
Read the next section to find out how to in-
terrupt the TIM standby function for the time
you are using a car wash.
Temporarily interrupting the TIM
standby mode
(before driving into a car wash)
• Switch off the radio before driving into
the car wash.
If the display goes out immediately, the TIM
standby mode is inactive and the motor an-
tenna will retract.
You can now drive into the car wash.
However, if "TIM on" briefly shows on the
display panel when you switch off the audio
system, the TIM standby mode is active.
• Press TIM for approx. 2 sec.
"Stby off" will appear briefly in the display.
The antenna will retract (please check) and
will remain retracted until the audio system
is switched back on.
Now the TIM standby mode is temporarily
inactive.
You can drive into the car wash.
The standby function will be automatically
re-activated when you switch the radio on
again. The power antenna will extend.
Important!
In order to prevent possible damage, do not
switch on the radio until you have left the
car wash!
77