Toshiba B-880-QQ SERIES Owner's Manual page 8

2. SPECIFICATIONS
Auto Ribbon Saving Mode
Auto ribbon saving function is activated by Parameter Settings (Refer to your authorized
TOSHIBA TEC representative) and none print area extends for more than 20 mm.
NOTES: 1. To activate ribbon saving function at a speed of 8"/sec., the no print area should extend
more than 25 mm.
2. Depending on the relationship between the outer diameter of rewound ribbon and print
speed, ribbon usage may vary as follows:
Print speed
3. Please contact your authorised TOSHIBA TEC representative to change the
Operation Panel setting.
2.2 OPTION
Option Name
Cutter module
Strip module
PCMCIA interface
board
NOTES:1. Available from your nearest TOSHIBA TEC representative or TOSHIBA TEC Head
Quarters.
Ribbon loss
3"/sec Approx. 5 mm
4"/sec Approx. 10 mm
8"/sec Approx. 23 mm
Type
B-4208-QM A stop and cut swing cutter
B-4908-H-QM This module strips the label from the back-
ing paper with the take-up block and strip
block.
B-8700-PC-QM
This board enables the following PCMCIA
cards to be used.
* LAN card: 3 COM EtherLink
mended)
* ATA card: Conforming to PC card ATA
standard
* Flash memory card: 4MB card
10-1.)
Description
2-2
2.2 OPTION
Source
See NOTE 1.
See NOTE 1.
See NOTE 1.
® III (recom-
(See Page
EO1-33017