Table of Contents
Advertisement
Front Panel Features
The NI PXIe-8830mc has the following front-panel features:
•
A system reset pushbutton (press the button to reset the processor module).
•
Four front panel LEDs that show PC status:
–
PWR OK/FAULT LED—Indicates the processor module status. The LED indicates
one of the following states:
•
Green ON steady—PXI Express and onboard power is on and within regulation
limits.
•
Green BLINKING—The processor module has entered the soft off state and is
safe to power down.
•
OFF—The processor module is powered off.
•
Red BLINKING—The processor module detected a power rail fault when
trying to boot.
•
Red Solid—The processor module detected a thermal fault and has shut down
to protect the system.
–
USER —Two bi-color green/yellow LEDs (USER 1 and USER 2) that you can
define to meet the needs of your LabVIEW application.
–
DRIVE —Indicates when an access to the internal hard disk is occurring.
Removing the NI PXIe-8830mc from a PXI Express
Chassis
To remove the NI PXIe-8830mc from a PXI Express chassis, complete the following steps.
1.
Power off the chassis.
2.
Remove any cables that may be attached to the processor module front panel.
3.
Unscrew the 4 bracket-retaining screws in the front panel.
4.
Press the injector/ejector handle down.
5.
Slide the unit out of the chassis.
Cleaning
Use a dry, low-velocity stream of air to clean the NI PXIe-8830mc processor module. If
needed, use a soft, nonmetallic brush for cleaning around components.
Make sure that the device is completely dry and free from contaminants before returning it to
service.
Note
Applicable only when chassis is set to Manual.
NI PXImc Devices Getting Started Guide | © National Instruments | 9
Advertisement
Table of Contents
