Dip Switch Functions - TEC B-450-QQ Series Owner's Manual

4. DIP SWITCH FUNCTIONS

4. DIP SWITCH FUNCTIONS
The DIP switches are located at the rear of the printer.
WARNING!
Turn the POWER OFF before
changing the DIP switches.
DIP SW
No.
ON/OFF
1
1 OFF
ON
2
OFF
ON
OFF
3
ON
OFF
4
ON
OFF
5
ON
6
OFF
6
ON
OFF
7
ON
8
OFF
ON
NOTES: 1. DIP Switch settings are read at power on time.
2. To enter the program download mode first set DIP SW #8 to ON. The printer will then enter
the relevant modes, as selected by DIP SWS #6 and #7. To initialize these modes hold
down the [FEED] or [FEED] and [PAUSE] keys whilst turning the power on. If the printer
is turned on without pressing a key, it will enter the program download mode.
Do not set the switches to the maintenance mode as this may cause a failure.
3. When DIP SW#8 is set to OFF, the backing paper thickness setting can be changed by
the following combination of DIPSWs #6 and #7.
No.6
OFF
ON
DIP SW
2
2400 bps
OFF
4800 bps
OFF
9600 bps
ON
19200 bps
ON
None
EVEN
Not available
Available
Available
Not available
7
OFF RAM clear mode (Maintenance counter)
OFF Threshold manual setting mode
ON Sensor adjustment mode
ON RAM clear mode (Parameter)
Normal operation mode
Program down load operation
No.7 Thickness of Backing Paper
OFF 70 m Thin Backing Paper
OFF 80 m Thick Backing Paper
Function
4-1
EO1-33006
4. DIP SWITCH FUNCTIONS
Fig. 4-1
Remarks
Transmission speed
(Baud rate)
Parity
Stacker
Auto media feed
Selectable only when
DIP SW #8 is ON.
Operating mode