Advertisement
SG Series: Head Wash Procedure
9. When prompted to [REMOVE CL-LIQUID 1 3] pull the 2 TR-CL pouches out just enough to disengage.
You do not have to completely remove the ink trays.
10. When prompted to [SET CL-LIQUID 1, 3]. Gently push the ink trays back into place until they engage.
The [WASHING HEAD] prompt will display. This process will repeat between 3 and 7 times.
11. Once the ink lines for channels 1 and 3 have been cleaned, the LCD display will prompt you to move
the ink trays currently in channels 1 and 3 to channels 2 and 4 which are the MG and BK channels. The
same series of prompts will display for channels 2 and 4 that occurred for channels 1 and 3.
12. At the end of the process you will be prompted to [REMOVE CL-LIQUID 2, 4] and to again [EMPTY
DRAIN BOTTLE]
DO NOT SKIP THIS
13. The LCD display will default back to the [SUB MENU/HEAD WASH] prompt.
off the sub power on the control panel as well as the main power at the rear of the machine. The
HEAD WASH process has now been completed.
Please consult the applicable setup guide when returning the printer to service.
STEP. Empty the drain bottle and press [ENTER].
DO NOT PRESS
ENTER. Turn
Advertisement
