Draytek Vigor2620 LTE Series User Manual page 441

S y n t a x
S y n t a x
Parameter
<command><parameter>|
...]
-M <n>
-S <isp name>
-P <on/off>
-u <username>
-p <password>
-a <n>
-t <n>
-i <ip address>
-w <ip address>
-n <netmask>
-g <gateway>
-A <idx>
-B <mode>
-V
-C <sim pin code>
-O <init string>
-T <init string2>
Vigor2620 Series User's Guide
D e s c r i p t i o n
D e s c r i p t i o n
Description
The available commands with parameters are listed below.
[...] means that you can Enter several commands in one line.
M means to set Internet Access Mode (Mandatory) and n
means different modes (represented by 0 – 3)
n=0: Offline
n=1: PPPoE
n=2: Dynamic IP
n=3: Static IP
n=A: 3G/4G USB Modem(PPP mode)
n=B: 3G/4G USB Modem(DHCP mode
It means to set ISP Name (max. 23 characters).
It means to enable PPPoE Service.
It means to set username (max. 49 characters) for Internet
accessing.
It means to set password (max. 49 characters) for Internet
accessing.
It means to set PPP Authentication Type and n means
different types (represented by 0-1).
n=0: PAP/CHAP (this is default setting)
n=1: PAP Only
It means to set connection duration and n means different
conditions.
n=1~999: Idle time for offline (default 180 seconds)
n=-1: Always-on
It means that PPPoE server will assign an IP address specified
here for CPE (PPPoE client).
If you type 0.0.0.0 as the <ip address>, ISP will assign
suitable IP address for you. However, if you type an IP
address here, the router will use that one as a fixed IP.
It means to assign WAN IP address for such connection.
Please type an IP address here for WAN port.
It means to assign netmask for WAN connection. You have to
type 255.255.255.xxx (x is changeable) as the netmask for
WAN port.
It means to assign gateway IP for such WAN connection.
Set to Always On mode, and <idx> as backup WAN#.
Set to Backup mode;
<mode> 0: When any WAN disconnect; 1: When all WAN
disconnect.
It means to view Internet Access profile.
Set SIM PIN code (max. 15 characters) for USB PPP mode.
Set Modem Initial String (max. 47 characters) for USB PPP
mode.
Set Modem Initial String2 (max. 47 characters) for USB PPP
mode.
429