Operating Procedures - Uni-ram URS500 Series User Manual

MANUAL - SOLVENT RECYCLERS - URS500, 600, 500EP2, 600EP2

OPERATING PROCEDURES

Wear protective clothing in accordance with local safety and environmental regulations. Use face goggles
and gloves as a minimum. Use an apron and respirator if required.
Summary of Operating Steps:
1) Open the Tank Lid and Safety Cover
2) Transfer Solvent to the Recycler Tank
3) Position Solvent Receiving Pail
4) Change temperature set point, as required
5) Start recycling
6) Finish Recycling
7) Transfer clean solvent
8) Remove debris
9) Clean Distillation Tank and Lid Surface
10) Install new liner bag
11) Inspect Lid Gasket, Remove and Replace if necessary
Each Step is described in detail below.
1) Open the Tank Lid and Safety Cover
• Open the safety cover.
• Open the inner lid by releasing the Lid Clamp.
• Make sure that Tank is empty and that a Liner Bag is properly installed in the Tank.
PULL UP TO OPEN. PUSH DOWN TO LOCK
2) Transfer Solvent TO the Recycler Tank
Verify that the solvent to be recycled complies with the requirements described in the section, Solvent
Requirements. Solvent can be put into the Distillation Tank by hand or by using the Transfer Hoses and
bulit-in Transfer System (EP2 Models only).
a) For models without the Solvent Transfer System
Pour the solvent into the Distillation Tank. Fill to 1.5 inches below the Retainer Ring.
Maximum volume is 5 gal (20 L) and minimum volume is 1.5 gal ( 6 L). Do not let the container of dirty
solvent touch the top of the recycler. When pouring the contaminated solvent, make sure all solvent goes
into the Liner Bag, not between the Liner Bag and Distillation Tank. Clean Lid Gasket and top of distilla-
tion tank. Close inner lid, engage lid clamp and close safety lid. Caution: Do not overfi ll Distillation Tank
because contaminated solvent could fl ow into Condenser and block the condenser passage way. Close
the Tank Lid, lock down the Lid Clamp and close the safety Cover.
LID CLAMP
TANK LID
9
Revision 2019-07