Failure Codes - Qwic Trend Series Manual

SET 2: Setting the speedlimiter
With the 'PLUS' and 'MINUS' you can adjust the
speedlimiter. With this you can limit the maximum
speed in which the motor provides power. This can be
handy if you prefer to drive on slower speeds.
SET 3: Setting the Tire-size
Set the correct tire-size for more exact information on
the screen. On the side of every tire you can find the
size. The pre-set sizes may deviate a little. This means
that the amount of driven kilometers has a maximum
deviation of 5%.
16 inch 50-305 Circumference: 1272 mm
20 inch 47-406 Circumference: 1571 mm
20 inch 53-406 Circumference: 1590 mm
24 inch 50-507 Circumference: 1907 mm
26 inch 50-559 Circumference: 2070 mm
28 inch 37-622 Circumference: 2187 mm
28 inch 40-622 Circumference: 2205 mm*
28 inch 42-622 Circumference: 2218 mm
28 inch 47-622 Circumference: 2249 mm
28 inch 50-622 Circumference: 2268 mm
* Standard your bike is provided with 40-622 tires
SET 4: (Speed) Units
With the 'PLUS' and 'MINUS' buttons you can switch
between kilometers (per hour) and miles (per hour).
SET 9: Battery information
With the 'PLUS' and 'MINUS' buttons you can see the
following information of the battery: The percentage of
the remaining battery-capacity, the total charging-cycli
and the actual battery voltage.

Failure codes

It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Error 1:
Error 2:
Error 3:
Error 4:
Error 5:
Error 6:
Error 7:
Error 8:
Error 9:
Display & Controls: Rearmotor and frontmotor models
Problem with 3-phase control from the
controller
Problem with throttle connection (start-
detection)
Motorcable 3-phase wiring loose or defective
Motorcable Hall Sensor signal malfunction
(malfunction in motor or motorcable)
Malfunction in brake sensor(signal)
Battery voltage too low
Motor stalled
Malfunction in controller (signal)
Malfunction in display (signal)
41