OPTO 22 groov EPIC User Manual page 71

CHAPTER 7: CONNECTING GROOV EPIC TO A NETWORK OR MULTIPLE NETWORKS
4. If you selected Manual, the Network configuration
page changes to display additional fields. You'll want
to refer to the values you entered in
Additional Gateways IP Addresses, DNS IP Addresses
and Name Servers, and Order"
– IP Address
– Subnet Mask
– Gateway Address
– DNS Server 1 and DNS Domain 1
These two fields must be specified as a set. If
you need to enter more than one set,
groov Manage displays fields to enter a second
and third set after you enter the previous set.
– Gateway Order
– DNS Order
5. Choose from the following:
– If you need to configure another network interface for wired communication, return to
– If you need to configure WLAN0 for wireless communications, go to
page 57.
– If you are done configuring the physical network interfaces, go to
page 58.
Configuring WLAN0
1. From the Network configuration page, click or tap the IPv4 Method in the Wi-Fi section and select the
connection method you want. groov Manage updates the Network configuration page as shown below
(automatic on the left, manual on the right):
2. Enter the information you collected in
3. Choose from the following:
– If you need to configure a network interface for wired communication, see
ETH1" on page 56.
– If you are done configuring the network interfaces, go to
"Table of
to fill out these fields:
"Collecting Network Configuration Information" on page
"Configuring WLAN0" on
"Saving the Configuration" on
"Configuring ETH0 or
"Saving the Configuration" on page
groov EPIC User's Guide
step 1.
51.
58.
57